Table of Contents
Advertisement
Exhaust pipes
The exhaust pipes are manufactured by Cub
Cadet. To remove/replace the exhaust pipes:
1.
Remove the muffler following the steps
described in the previous section.
2.
Remove the mounting bolts using a 1/2" wrench.
See Figure 2.7.
Remove these bolts
Figure 2.7
3.
DIscard the old exhaust gaskets. Clean all gas-
ket material from the cylinder head (and exhaust
pipe if it is being reused.
4.
Using new gaskets, install the exhaust pipes fol-
lowing the above steps in reverse order.
Fuel tank removal/replacement
Remove/replace the fuel tank by following these steps:
Gasoline and it vapors are
! CAUTION
! CAUTION
extremely flammable. Use common
sense when working around the fuel
system
1.
Remove the deck.
2.
Remove the fender by following the steps
described in Chapter 4: Body/Chassis.
3.
Remove the hair pin clips retaining the deck lift
cables and disconnect the cables.
See Figure 2.8.
Hair pin clip
4.
Unhook the deck lift assist spring.
See Figure 2.9.
5
ENGINE RELATED PARTS
Deck lift cable
Figure 2.8
Deck lift assist spring
Figure 2.9
Advertisement
Table of Contents
