Table of Contents
Advertisement
STEERING-HYDROGEAR
3.
At the bottom of the lever with the cam slot there
is a connector link. Remove the hairpin clip and
push it out of the lever. See Figure 6A.20.
Figure 6A.20
4.
Disconnect the steering links on both sides:
4a. Gently pry the link retainer over the master
link. See Figure 6A.21.
Steering link
Figure 6A.21
56
Remove hair pin
clip
Retainer
5.
Remove the transmission dampener cylinder
using two 1/2" wrenches. See Figure 6A.22.
Transmission dampener
Figure 6A.22
6.
Remove the steering shaft by removing the two
clamp bolts in the steering shaft receiver and lift-
ing the shaft out. See Figure 6A.23.
Steering shaft
Figure 6A.23
Steering shaft
Receiver
Advertisement
Table of Contents
