Table of Contents
Advertisement
5.
Remove the nuts from the under side of the foot
rests. See Figure 4.16.
Remove these nuts
Figure 4.16
6.
Remove the brake and drive pedals.
7.
Remove the screw from the center of the fender.
See Figure 4.17.
Remove this screw
Figure 4.17
8.
Remove the fuel cap.
9.
Standing behind the tractor, lift the fender up till it
clears the studs for the seat.
10.
Place the steering wheel on the steering shaft.
Turn the wheels to the left and right to allow the
fenders to clear the steering arm assembly.
See Figure 4.18.
Place some tape
here to protect the paint
NOTE: When lifting the fender off of the tractor,
clear the left side first and rotate the fender to
clear the deck lift lever.
11.
Install the fender by following the previous steps
in reverse.
21
BODY/CHASSIS
Steering arm assembly
Figure 4.18
Advertisement
Table of Contents
