Hardware Setup; Quick Setup - HP xw4100 Setup And Troubleshooting Manual

2

Hardware Setup

Quick Setup

1. After unpacking your HP Workstation, locate an accessible workspace to set up the system and
connect the mouse, keyboard, and power cables to your workstation. Connect the power cable
from the workstation to a power outlet.
Figure 2-1
NOTE
with the device. For more information on your HP Workstation, refer to the Documentation
and Diagnostics CD or visit http://www.hp.com/go/workstationsupport.
2. Connect the monitor cables to the cable connector and connect the cable connector to the graphics
card as shown in the figure above. (If using only one monitor, or a graphics card with two outputs,
a cable connector may not be required.) Connect the power cables from the monitors to a power
outlet.
ENWW
Workstation setup
Connect other components, such as a printer, according to the instructions included
Quick Setup 3