Download  Print this page

Calling Technical Support - HP xw4100 Setup And Troubleshooting Manual

Hp xw series workstations.
Hide thumbs

Advertisement

Table 4-3
Diagnostic Lights and Audible Codes (continued)
Activity
System does not power on
and LEDs are not blinking.
No beeps.
*
Refer to your workstation's Service and Technical Reference Guide for BIST information.

Calling Technical Support

At times you may encounter an issue that requires technical support. When you call technical support:
Be in front of your workstation.
Write down the workstation serial numbers, product numbers, model names, and model numbers
and have them in front of you.
Note any applicable error messages.
Note any add-on options.
Note the operating system.
Note any third-party hardware or software.
Note the details of any blinking LEDs on the front of the workstation.
22
Chapter 4 Troubleshooting
Possible Cause
System unable to power on.
Recommended Action
CAUTION
Internal components may be powered even when
the system is off. To prevent damage, disconnect the workstation
power cord before you remove a component.
Press and hold the power button for less than 4 seconds. If the hard drive
LED turns green, then:
1.
Remove the expansion cards one at a time and try holding the power
button again for less than 4 seconds.
2.
The problem may be on the system board. Contact HP for
assistance.
OR
Press and hold the power button for less than 4 seconds. If the hard drive
LED does not turn on green then:
1.
Check that unit is plugged into a working AC outlet.
2.
Open the access panel and check that the power button harness is
properly connected to the system board.
3.
Check that ALL power supply cables are properly connected to the
system board.
4.
Check the power supply functionality
a. Disconnect the AC power.
b. Disconnect ALL internal power supply cables.
c. Plug in the AC power.
If the power supply fan spins and the BIST
supply is functional. The problem may be on the system board.
Contact HP for assistance.
If the power supply fan does not spin or the BIST
the problem may be in the power supply. Contact HP for assistance.
LED lights, the power
*
LED does not light,
*
ENWW

Advertisement

Table of Contents

   Related Manuals for HP xw4100

Comments to this Manuals

Symbols: 0
Latest comments: