10Bt/100Tx Lan Features; Remote Power On - HP Kayak XA Technical Reference Manual

Vstandby requirements
supporting RPO
Optional Bootrom Socket
NOTE
Flash / ROM Devices
3 Interface Devices and Mass-Storage Drives
10BT/100TX LAN Controller

10BT/100TX LAN Features

Feature: Description:
LAN Controller AMD PCNET-Fast chip
RJ45 Connector 10BT/100TX autonegotiation
Remote Boot Protocols integrated in System BIOS
ExtStart Connector • Connection to CPU board
• LAN remote power on signals

Remote Power On

• Full remote power on with Magic Packet
Remote Wake Up • Wake Up from Suspend state with Magic Packet
Remote Power On
Remote Power On (RPO) is available at 10 and 100 Mbits per second.
The Vstandby requirements for HP network cards supporting RPO, is:
• A power supply able to deliver at least 250mA on Vstandby output. This is
the case for all HP Kayak systems.
It is possible to add a flash device on the network card socket with a specific
LAN bootrom code. This new bootrom code will be seen and mapped
automatically by the system BIOS instead of the embedded version (system
BIOS).
At the time this TRM was produced, there was no flashing tool available to
allow you to update the bootrom content in the flash on the LAN adapter. A
flashing tool for any AMD based card may be available, but in order to use this
tool on HP cards, only 29fxxx flash devices must be used. At present, no test
has been carried out using this tool on HP cards.
The 10BT/100TX card provides a PLCC 32-pin socket and any size of flash
device can be used up to 256KB§.
62