Electrical Connection - Notes; Connect The Cable To The Outdoor Unit - Notes - Sea Breeze SMZ42H46ZOGX Installation Manual

WARNING! Improper wiring between the inside units and the outside unit can cause serious damage to
the system, and the risk of personal injury or fire. Use caution when connecting the wiring
to insure that the wires are connected properly.
DO NOT USE THERMOSTAT WIRE TO CONNECT OUTDOOR TO INDOOR UNIT!
NOTES:
- Electrical wiring and connections should be made by qualified electricians in accordance with National and
Local electrical codes and regulations.
- Proper grounding is a must.
- Voltage should not vary beyond +/- 10% of the rated voltage.
- See the specifications page for proper wire sizes and circuit breaker sizes.
- Connect the control cables according to the diagrams on page 15.
- Make power connections per diagram on page 15.
- Remove the handle on the right side of the outdoor unit.
- Remove panel on the right front.
- Remove the cable clamp and connect the power connection cable to the terminal.
- Wiring should be terminal to terminal and to correct indoor unit. Do not cross wires!
- Reattach the cable clamp.
- Reinstall the handle.
Connect the Cable to the Outdoor Unit
For model: SMZ42H46ZOCX.
1. Remove screws to take off front side panel.
2. Feed cable wire through knock-out holes the grummets on the right side panel. (A water tight cable strain
relief or conduit is recommended here.)
3. Connect the wires to the terminals. (See wiring diagram Figure 16).
4. Replace front side panel with the screws.
Secure wire cables.
5.
If a condensate pump is needed it should be connected to the
950-0203-revK
ELECTRICAL CONNECTION
- 14 -
supply power
at the Outdoor Unit
March 1, 2016