HP Vectra VL600 User Manual page 16

The total length of the
external SCSI cables
should not exceed 3 meters
(approximately 10 feet).
Minitower
SCSI Mode Setting For
External Devices
(Symbios cards only)
1 Setting Up and Using Your PC
Connecting an External SCSI Accessory (Some Models Only)
3 Connect the SCSI accessory to your PC's external 16-bit SCSI
connector with a shielded SCSI cable.
4 Refer to the manual provided with the SCSI accessory to learn how
to install any software that may be necessary to use it.
It is strongly recommended that you switch to 8 bit asynchronous mode when
connecting an external SCSI device. To do this, enter the Symbios
Configuration Utility during PC startup by pressing F6, select SYM53C895,
then select Device Selection and SYM53C895. Set the Sync Rate to
OFF and the Width to 8 bits.
16
Make sure the SCSI
accessory is terminated