Installing optical drives
WARNING
To avoid electrical shock and harm to your eyes by laser, do not open the laser module. The laser module should be serviced
by service personnel only. Do not attempt to make any adjustment to the laser unit. Refer to the label on the CD-ROM for
power requirements and wavelength. This product is a class 1 laser product.
Desktop models
1 Switch off the PC and remove the PC's cover and front panel. Refer to page 8.
2 Press the two latches inwards and slide out the drive tray.
3 Remove the metal filler plate from the tray.
4 Place the new drive in the tray with the correct orientation and tighten the tray's four screws (two on
each side).
5 Slide the drive tray back into the PC until it clicks into place.
Fit the two screws to the front of the tray if you had to remove them earlier.
6 Attach all data and power connectors. If you are installing a CD-ROM, CD-RW or DVD drive, connect
the audio cable too.
audio connector
(optional)
7 Replace the cover and front panel. Refer to page 10.
filler plate
Upgrading and replacing hardware
19