Installing An Accessory Card - HP Vectra VL410 Upgrade Manual

Upgrading and replacing hardware

Installing an accessory card

Desktop models
1 Switch off the PC and remove the PC's cover. Refer to page 8.
2 Remove the retaining bracket.
3 Remove the slot cover and store it in a safe place in case you need it again.
4 Aligning the card carefully, slide it into position and press it firmly into the slot.
5 Replace the retaining bracket.
6 The accessory card may need a special connection, such as from an optical drive if you are installing
an add-on sound card.
I I I I n n n n t t t t e e e e g g g g r r r r a a a a t t t t e e e e d d d d A A A A u u u u d d d d i i i i o o o o C C C C o o o o n n n n n n n n e e e e c c c c t t t t o o o o r r r r
If you install an add-on sound card, remove
the cable in this connector and insert it into
the sound card's connector.
7 Replace the cover.
24