HP Vectra VL410 Upgrade Manual page 25

Small Form Factor models
1 Switch off the PC and remove the PC's cover. Refer to page 8.
2 Remove the accessory board bracket.
3 Remove the retaining clip.
4 Remove the slot cover and store it in a safe place in case you need it again.
5 Aligning the card carefully, slide it into position and press it firmly into the slot.
6 Replace the retaining clip.
7 Replace the accessory card bracket.
8 The accessory card may need a special connection, such as from an optical drive if you are installing
an add-on sound card.
I I I I n n n n t t t t e e e e g g g g r r r r a a a a t t t t e e e e d d d d A A A A u u u u d d d d i i i i o o o o C C C C o o o o n n n n n n n n e e e e c c c c t t t t o o o o r r r r
If you install an add-on sound card, remove
the cable in this connector and insert it into
the sound card's connector.
9 Replace the cover.
Upgrading and replacing hardware
25