HP Vectra E-Vectra Deployment Manual page 16

HP Toptools
Any toptools components already installed on the target system will be shown selected in the component
selection dialog. When Next is pressed, those components checked will be installed, and those
unchecked will be uninstalled. Any installed toptools components with versions newer than those on the
toptools media will not be touched.
The toptools device manager is not a selectable component. It is always selected for install and is only
unselected when uninstalling all of toptools. The toptools device manager will not be installed each time
the HP Toptools installation wizard is run, it will automatically be deselected if the same or newer version
is found installed.
It is suggested that you install toptools on an NTFS partition in order to benefit from the user model and
provide better security. Choose the destination accordingly in this section. Once you have chosen
destination and components click Next to continue.
Step 7. Integration selection
The integration selection dialog allows you to select integration or linkage, modules to configure with
toptools. Select the desired integration and click Next to continue.
- Note -
The "workgroup node manager" entry will only be displayed if hp workgroup node manager was
found installed on the target system. Be aware the "workgroup node manager" is part of the
Openview Professional Suite, a discontinued product. For information on how to integrate HP
Toptools with Openview Network Node Manager, refer to the HP Toptools web page at
www.hp.com/toptools
Step 8. HP Web JetAdmin integration
Because HP Web JetAdmin can run stand-alone, it may already be present on the HP Toptools system.
If it is present and Web JetAdmin is selected for installation, the HP Toptools installation wizard will create
a link to the installed Web JetAdmin if the version matches or is newer than that on the toptools media. If
the version of Web JetAdmin installed is older than the version on the toptools media, then the
component will be installed (upgraded) and then linked.
If Web JetAdmin is not installed on the HP Toptools system and it is selected for installation, you will be
presented with a dialog asking if you would like to install the Web JetAdmin software, or if you would like
to link to a Web JetAdmin installation which may be present on another system somewhere on the
network. Select your preference, fill in the needed information for Web JetAdmin, and click Next to
continue.
HP Toptools Deployment Guide Version 5.5
16