HP Vectra E-Vectra Deployment Manual page 103

HP Toptools
Check that SNMP services are started.
Review the SNMP status of servers by clicking the Server Status tab. Check that they are properly
initialized to use Auto Alert. If not, correct the problem at the HP Netserver. All servers must have an UP
status to be properly configured for Auto Alert.
Your HP Toptools Auto Alert installation is complete.
After you have installed HP Toptools Auto Alert, it is auto-started every time you start the PC console and
you may minimize it to the task bar. It is necessary for HP Toptools Auto Alert to always be running in
order to receive alerts. To stop HP Toptools Auto Alert simply close the application. Remember that you
will then have to launch the Toptools Auto Alert program from the program group in order to receive
alerts.
HP Toptools Deployment Guide Version 5.5
103