HP Vectra E-Vectra Deployment Manual page 64

4. Copy the alternate configuration file for the SNMP service (see item 6 - Important Notes):
# cp -f /tmp/snmpd.conf /etc/snmp/
5. Install the Curl package (see notes below):
# rpm -U /tmp/curl-7.7.2-yy_zzz.i386.rpm
6. Install the Netserver core component (see notes below):
# rpm -U /tmp/hpserver-core-5.02.xx-yy_zzz.i386.rpm
7. Install the Netserver Agents package (see notes below):
# rpm -U /tmp/agents_lx-5.50.xx-yy_zzz.i386.rpm
8. Register the SNMP daemon for automatic execution:
Edit /etc/rc.config and replace the string "no" for "yes" at
the START_SNMPD field.
9. Start the SNMP daemon, if it is not already running:
To verify its status, type:
# /sbin/init.d/snmpd status
To start it, type:
# /sbin/init.d/snmpd start
10. No system reboot is necessary.
For Debian:
1. Download the zip file containing the appropriate Agents installation files for your version of Linux (the
installation files are separated in directories named by distribution version).
2. Expand the zip file containing the Netserver Agents to a temporary location on your Linux system
(for example /tmp)
# unzip -o <name_of_the_package> -d /tmp
E.g.,
# unzip -o customer.zip -d /tmp
3. Install the UCD SNMP packages:
# dpkg -i -G /tmp/libsnmp-base_4.2.1-4_all.deb
# dpkg -i -G /tmp/libsnmp4.2_4.2.1-4_i386.deb
# dpkg -i -G /tmp/snmp_4.2.1-4_i386.deb
# dpkg -i -G /tmp/snmpd_4.2.1-4_i386.deb
3.1. Edit the file /etc/default/snmpd and change the value of TRAPDRUN to "no" (without the quotes).
3.2. Restart the SNMPD daemon:
# /etc/init.d/snmpd restart
4. Copy the alternate configuration file for the SNMP service (see item 6
- Important Notes):
# cp -f /tmp/snmpd.conf /etc/snmp/
5. Install the Curl package:
# dpkg -i -G /tmp/libcurl_7.7.2-1_i386.deb
6. Install the Netserver core component:
# dpkg -i -G /tmp/hpserver-core-5.02.xx-yy_debian22.i386.deb
7. Install the Netserver Agents package:
7.1 Before installing agents-lx, if there are hard disk cage devices, look for special files /dev/sg*. If
there are no such files, create them using the following commands:
HP Toptools Deployment Guide Version 5.5
HP Toptools
64