Advertisement
Made in the USA
FOOTSWITCH
by SLM Electronics
1400 Ferguson Ave.
IN 1
IN 2
St. Louis, MO 63133
CLASS
2
9-10VAC / 50-60Hz
GFX-1000
1000-2000mA
11
12
11 POWER JACK: Plug the small connector from the AC power pack
into this jack. Plug the power pack into a suitable source of the
proper AC voltage, as indicated on the power pack.
NOTE: The processor is always on when the power pack is
plugged in and connected to the unit. It is advised that you
unplug the power pack from the AC source when not using
the processor for extended time periods.
12 FOOTSWITCH JACKS: Up to 16 presets can be accessed and
assigned to your amplifier by proper use of footswitches. See
pages 25 through 34 for complete details and instructions.
13 LEFT OUT / STEREO OUT (PHONES / HI-Z): This jack serves
two purposes: (1) When using the processor in a stereo mode,
connect a mono signal cable from this jack to your left-channel
amp. (2) When using headphones with the processor, plug them
into this jack. When the processor is connected to an Insert/Effects
Loop jack (single jack, not loop), this jack is not used. (See pages
9, 10.)
14 R/MONO OUT / INSERT (STANDARD): This jack serves two pur-
poses: (1) When using the processor in a stereo mode, connect a
mono signal cable from this jack to your right-channel amp. (2)
When using an amp's INSERT jack, connect a stereo signal cable
from this jack to the Insert jack on the amp - if it's "non-inverting"
(see the drawing beneath #16). If the Insert jack is inverting, use
#16, not this jack. (See page 10.)
15 LEFT IN / STEREO IN: This jack serves two purposes: (1) When
using a stereo preamp or guitar with two mono outputs, connect
a mono signal cable from the left channel output to this jack. (2)
When using a stereo preamp or guitar with a single stereo out-
put, connect a stereo signal cable from its output to this jack. (See
pages 9, 10.)
16 R/MONO IN / INSERT (INVERTED): This jack serves two purpos-
es: (1) When using the processor in a stereo mode, connect a
mono signal cable from this jack to your right-channel amp. (2)
When using an amp's Insert jack, connect a stereo signal cable
from this jack to the Insert jack on the amp - if it's "inverting" (see
the drawing below). If the Insert jack is non-inverting, use #14, not
this jack. (See page 10.)
NON-INVERTING
(STANDARD):
TIP = RETURN
G G
F F
X X
G G
F F
X X
T T
h h
T T
h h
OUT 1
OUT 2
LEFT
STEREO OUT
0000001
(PHONES / HI-Z)
13
INVERTING
RING = SEND
TIP = SEND
SLEEVE = GROUND
/ /
B B
F F
X X
- -
1 1
0 0
0 0
0 0
/ /
B B
F F
X X
- -
1 1
0 0
0 0
0 0
e e
R R
e e
a a
r r
P P
a a
n n
e e
e e
R R
e e
a a
r r
P P
a a
n n
e e
OUT
IN
R / MONO
LEFT
R / MONO
INSERT
STEREO IN
INSERT
(STANDARD)
(INVERTED)
RETURN
SEND
SEND
RETURN
14
15
16
(NOT AS COMMON):
RING = RETURN
SLEEVE = GROUND
l l
l l
Advertisement
