Advertisement
T T
h h
e e
F F
r r
o o
n n
t t
P P
T T
h h
e e
F F
r r
o o
n n
t t
INPUT
MIX
OUTPUT
CLIP
1 2
3
4
1 CLIP LED: This LED will light up when the input signal level is set
too high, indicating clipping of the input signal. For proper opera-
tion this LED should NOT light up when using the processor. (See
#2.)
2 INPUT: This control sets the level of the signal going into the
processor. For proper operation, turn this control up until the CLIP
LED (#1) starts to flash when playing at your loudest levels, then
back it down a little until the LED stops flashing. This insures the
best signal-to-noise ratio without distortion.
3 MIX: This control adjusts the mixture of the original signal and the
applied effect at the processor's outputs. The further to the right
you turn this control, the more effect is applied.
4 OUTPUT: This control adjusts the output level of the signal from
the processor. Typically this control is set for "unity gain" - that is,
the output level is the same as the input signal level. You may, of
course, use the settings that best suit your playing style.
5 PRESET LEDS: The primary function of these LEDs is to show
which preset you have selected. The #4 LED also serves as the
LEVEL indicator when in the EDIT mode. All four LEDs also serve
as 100's-place indicators for the digital display when using the test
tones and metronome. (See pages 20, 22.)
6 PRESET SWITCHES: The primary function of these momentary
push button switches is to select a preset effect. The #4 selector
also toggles between LEVEL and STYLE when in the EDIT mode.
(See page 14.)
7 STYLE LED: This LED is only used in the EDIT mode, showing
that the changes made to the program will effect a certain para-
meter, rather than the output level for that effect. (See page 14.)
8 DIGITAL DISPLAY: This multi-purpose two-digit display shows
various information, depending on the operating mode:
Basic Operation: Program setting chosen
Editing Parameters: Level and style of parameter being changed
Test Tones: Frequency (in hertz) of tone selected
Tuner: String being tuned and if sharp, flat, or right on
Metronome: Output level / tempo
9 EDIT LED & SWITCH: These are used in the EDIT mode, allow-
ing you to change the levels and styles of the effects. (See page
14.)
10 PROGRAM: The primary function of this control is to select an
effect. This control also serves as the parameter modifier control
when in the EDIT mode. (See page 14.)
a a
n n
e e
l l
P P
a a
n n
e e
l l
1
2
3
LEVEL
5
6
G G
F F
X X
/ /
B B
F F
X X
G G
F F
X X
/ /
B B
F F
X X
PROGRAM
ON
4
STYLE
EDIT
7
8
9
10
- -
1 1
0 0
0 0
0 0
- -
1 1
0 0
0 0
0 0
Advertisement
