Table of Contents
Advertisement
NOTE: A Phillips screwdriver is required.
1) Remove all the contents from inside of the vacuum cleaner container.
2) Attach the carry handle into the slots located on the top of the power head. Secure them with
supplied screws (Fig. 1).
3) Turn the container upside down and insert the feet with casters into the slots and apply
pressure until they click into place. Secure them with supplied screws (Fig. 2).
4) Your vacuum cleaner comes ready for dry vacuum cleaning with the reusable cloth filter pre-
installed. If the reusable cloth filter is not installed, refer to page 10.
5) For wet vacuuming, replace the reusable cloth filter with the foam filter supplied. If the foam
filter is not installed, refer to page 10.
6) Secure the power head back on the container using the 2 side latches. Insert the locking end of
the hose into the suction port of the container (Fig. 3).
7) Choose the desired accessories and/or extension wands and push fit onto the hose nozzle.
ASSEMBLY
9
Advertisement
Table of Contents
