Table of Contents
Advertisement
IMPORTANT! When vacuuming large quantities of liquids, do not immerse the nozzle completely;
leave a gap at the tip of the nozzle to allow air inflow. The machine is fitted with a float valve ( ② )
that stops the suction action when the container reaches its maximum capacity (Fig. 8). You will
notice an increase in motor noise. When this happens, turn off the machine, disconnect from
power supply, and drain the liquid.
3. Blower Operation
WARNING!
WARNING!
BE INHALED.
1) Make sure the container and any collected waste is emptied before using as a blower.
2) Insert the locking end of the hose into the blowing port on the rear of the power head (Fig. 9).
3) Turn on the motor on by turning the switch to the 'I' ON position.
4) Once you have completed blowing, switch to the "O" OFF position and unplug the power cord
from the power outlet.
KEEP BYSTANDERS CLEAR FROM BLOWING DEBRIS.
WEAR A DUST MASK IF BLOWING CREATES DUST THAT MIGHT
11
Advertisement
Table of Contents
