Table of Contents
Advertisement
1-10. Removing/Reinstalling the 68-pin
Connector (CN-2494/2495 Board)
n
The disconnections/connections of the fine pitch coaxial
cables are required for Removing/Reinstalling the 68-pin
Connector (CN-2494/2495 Board).
It is recommended to perform the disconnections/connec-
tions of the fine pitch coaxial cables in a clean place
(dustless location).
1. Open the R panel assembly to remove the L panel
assembly. (Refer to Section 1-3.)
2. Pull out the DPR-255 board and IF-936 board.
3. Remove the five screws to remove the VPR bracket.
DPR-255 board
IF-936 board
1-18 (E)
4. Remove the four screws from the connector plate
5. Disconnect the harnesses from the connectors CN3,
P2.6 x 6
CN-2494 board
PSW
2.6 x 6
CN-2495 board
P2.6 x 6
VPR bracket
(68P).
CN4, and CN5 on the CN-2494 board.
P2 x 4.5
P2 x 4.5
< Back view >
CN5
CN4
CN3
Connector plate
(68P)
WLL-CA55
Advertisement
Table of Contents
