Table of Contents
Advertisement
1-8-2. Forming the Flexible Card Wire
If using a new flexible card wire, hand form as shown in
the figure in advance.
n
Never reform the flexible card wire after being folded
once.
SW-1190 board CN3 5
5
5
5
5 EL display
15 mm
SW-1190 board
(CN3)
Insulated
surface (Blue)
25 mm
5
5
MB-1022 board CN17 5
5 CN-2517 board CN1
5
25 mm
CN-2517 board
(CN1)
Insulated
surface (Blue)
WLL-CA55
EL display
Insulated
surface (Blue)
MB-1022 board
(CN17)
Insulated
surface (Blue)
130 mm
1-9. Removing/Reinstalling the PS-668
Board and Transmitter
1. Open the R panel assembly, and remove the L panel
assembly and bottom plate. (Refer to "1-3. Removing/
Reinstalling the Exterior Parts")
2. Disconnect the flexible card wire from the connector
CN2 and the harnesses from the connectors CN3 and
CN4 on the PS-668 board.
n
Be careful not to bend the flexible card wires. This
shortens the wire life.
3. Disconnect the coaxial cable from the connector CN6
and harness from the connector CN10 on the MB-1022
board.
n
When disconnecting the coaxial cable, do not attempt
to remove by pulling the cable. Be sure to hold the
plug to remove.
4. Remove the three screws, and remove the spacer.
PS-668 board
Spacer
M2 x 4.5
CN3
CN4
OK Hold the plug to
remove.
MB-1022 board
CN2
CN6
CN10
Coaxial
cable
Do not attempt to
NG
remove by pulling
the cable.
1-15 (E)
Advertisement
Table of Contents
