Attaching With The Soft Case; Changing The Direction Of The Belt Clip; Wrapping The Microphone Cable Around The Soft Case; Removing The Unit From A Belt - Sony DWT-B01N Operating Instructions Manual

Attaching With the Soft
Case
The transmitter can be attached to the user with the
supplied soft case.
Changing the direction of the belt
clip
The belt clip attached to the rear of the soft case can be
rotated 0, 90, 180, or 270 degrees in relation to the unit.
When changing the direction of the belt clip, rotate the clip
while pressing the switch at the top of the clip, and make
sure that the clip is locked into place at your desired
position.
Wrapping the microphone cable
around the soft case
A hook and loop fastener is located at the bottom rear of
the soft case for securing the lavalier microphone's cable
after the unit is inserted into the case.
By wrapping the microphone cable that is connected to the
unit around this fastener, you can adjust the length of the
cable and reduce the stress that is applied to the unit when
the cable is pulled.
Rear
Hook and loop fastener
Front

Removing the unit from a belt

When the soft case is attached to a belt with the unit's
antenna pointing up, be careful to avoid getting the soft
case's hook and loop fastener caught on the belt during
removal.
The hook and loop fastener may open if it gets caught on
the belt.
To avoid contact between the fastener and belt, tilt the
bottom of the soft case outward (Fig. 1) or rotate the case
to the left or right (Fig. 2) during removal.
Fig. 1
14
Belt
Hook and loop
fastener