Table of Contents
Advertisement
12. Remove the five screws, and remove the PS-645 board
from the heat sink (PS).
13. Unsolder the transmitter from the PS-645 board.
14. Remove the cool sheet PS from the transmitter.
Transmitter
Cool sheet (PS)
PS-645 board
Unsolder
PSW3 x 6
15. Reassemble the PS-645 board and transmitter in the
reverse order of removal.
n
When connecting the coaxial cable, hold the plug and
connect the coaxial cable to the connector vertically.
Press the plug into the connector by small turning to
the left and the right.
Hold the plug to connect
Connecting connector
WLL-CA50
PSW3 x 6
Unsolder
Heat sink (PS)
1-9. Removing/Reinstalling the 40-pin
Connector
1. Remove the two stepped screws, and remove the sheet
(40P).
2. Remove the six screws and remove the 40-pin bracket.
P2.6 x 6
Sheet (40P)
Stepped
screws
3. Unsolder the harness (CAMERA), and remove the 40-
pin connector.
40-pin connector
Harness
(CAMERA)
40-Pin bracket
P2.6 x 6
Camber
40 spots
1-9 (E)
Advertisement
Table of Contents
