Table of Contents
Advertisement
6. Pull out the CN-2494/2495 board as shown in the
figure, and disconnect the fine pitch coaxial cable from
the connector CN2 on the CN-2494/2495 board.
n
Be careful not to bend the fine pitch coaxial cables.
This shortens the wire life.
When disconnecting the fine pitch coaxial cable, do
not attempt to remove by pulling the cable. Be sure to
hold the connector to remove.
Fine pitch coaxial cables
CN-2494 board
CN2
CN2
CN-2495 board
Hold the connector to remove.
OK
Do not attempt to remove by pulling
NG
the cables.
WLL-CA55
7. Attach the new 68-pin connector (CN-2494/2495
Board) in the reverse order of removal.
m
. When connecting the fine pitch coaxial cable, hold
the connector, and align the polarity marks. Then
connect the fine pitch coaxial cable to the connector
straight.
Hold the conector to connect.
OK
Not to bend the cable.
NG
. Check the arrangement of the harness (CAM MIC)
before reattaching the L panel assembly.
(Refer to Section 1-7.)
Polarity marks
1-19 (E)
Advertisement
Table of Contents
