Communication With A Pc; Hardware Standard Rs 232-C - THORLABS PRO8 Series Operation Manual

_________________________________________________________________________________

4 Communication with a PC

The following operating elements are still working with the remote control
active: The key

4.1 Hardware standard RS 232-C

The RS232C interface complies to the IEEE1174 standard for programmable
instruments.
To use the implemented RS232C interface, first select this option in the setup menu.
Then select the desired baud rate (default is 19200 Bd).
If you use an older PRO8 system it will have a female 9-pin D-SUB connector at the
rear panel. You must use then an 1:1 connection cable between PRO8 and PC.
_____________________________________________________________________________________________________
© 2012 Thorlabs
NOTE
, the LEDs SEL, ERR and ON and all potentiometers
at the modules themselves
PRO8000 SETUP
Interface:
232C
IEEE Adr.:
PRO8000 SETUP
IEEE
10
Baudrate
Hardware standard RS 232-C 17
RS-
10
CHANGE
Adr.
: 19200
CHANGE
:
_