Figure 8. Vpn Card Installation - ADTRAN NetVanta 5305 Hardware Installation Manual

Hardware Installation Guide
Step
1. Remove power from the unit.
2. Use a screwdriver to take the screws out the system Controller module. Remove the module.
3. Gently slide the accelerator card into the PC card slot as shown. The card is keyed to fit into the
slot only one way. To avoid damaging the card pins, do not use excessive force.
4. Slide the system Controller module into the Controller slot until the module is firmly positioned
against the chassis.
5. Secure the screws at both edges of the module. Tighten with a screwdriver.
6. Restore power to the unit.
1
2
3
26
Instructions for Installing the VPN Accelerator Card

Figure 8. VPN Card Installation

© 2004 ADTRAN, Inc.
Action
NetVanta 5305
CAUTION:
REMOVE POWER CORD PRIOR
TO REMOVAL OF POWER SUPPLY
85-130VAC/190-250VAC
4A/2A 50/60Hz
61200990L1-34C