NetVanta 3000 Series Hardware Installation Guide
Installing the NetVanta VPN Accelerator Card (1202368L1)
The optional VPN Accelerator Card plugs into a 32-bit PCI slot and is designed to be used in the
NetVanta 3305 to provide encryption/decryption and security acceleration services. The card provides the
following security services to the host processor: DES, Triple-DES, AES, SHA-1, MD5, and Random
Number Generation. Performance metrics include 528 Mbps-DES, 176 Mpbs-3DES, and 422 Mbps-AES.
The power consumption of the card does not exceed 2 watts.
Step
1
Remove power from the unit.
2
Remove the nine screws and, if necessary, two mounting brackets (see Figure 21).
3
Using a 3/16" hex driver, remove the two jack screws located on either side of the DB-9 port.
4
Carefully lift and remove the unit's cover to expose the circuit board.
5
Gently slide the accelerator card into the PC card slot as shown. The card is keyed to fit into the
slot only one way. To avoid damaging the card pins, do not use excessive force.
6
Replace the unit cover, screws, and mounting brackets.
7
Restore power to the unit.
61200860L1-34E
Instructions for Installing the VPN Accelerator Card
Figure 21. VPN Card Installation
© 2004 ADTRAN, Inc.
Action
Unit Installation
49