Conductivity/Tds Measuring And Calibration Procedure - Lutron Electronics WA-2017SD Operation Manual

6. CONDUCTIVITY/TDS MEASURING
and CALIBRATION PROCEDURE
The meter default function are following :
* The display unit is set to conductivity ( uS, mS ).
* The temperature unit is set to
* Temp. compensation factor is set to 2.0% per C.
* Auto range.
* Auto power off.
* The sampling time of data logger function is
2 seconds.
If the meter along with the conductivity
probe are used for a certain period,
then it should execute the calibration
procedures, refer chapter 6-3, page 21.
.
℃
19
Fig. 3