Table of Contents
Advertisement
Standby Power
The +5V Standby Power header is located at JSTBY1 on the motherboard. You must have
a card with a Standby Power connector and a cable to use this feature. Refer to the table
below for pin definitions.
Disk On Module Power Connector
One power connector for a SATA DOM (Disk On Module) device is located at JSD1. Connect
the appropriate cable here to provide power support for your Serial Link DOM device.
IPMI SMBus Header
A System Management Bus header for IPMI 2.0 is located at JIPMB1. Connect the appropriate
cable here to use the IPMB I
definitions.
Power SMB (I
C) Header
2
The Power System Management Bus (I
fan, and system temperatures. Refer to the table below for pin definitions.
Standby Power
Pin Definitions
Pin#
Definition
1
+5V Standby
2
Ground
3
NC
DOM Power
Pin Definitions
Pin#
Definition
1
5V
2
Ground
3
Ground
C connection on your system. Refer to the table below for pin
2
External I
C Header
2
Pin Definitions
Pin#
Definition
1
Data
2
GND
3
Clock
4
NC
C) connector (JPI
2
Power SMB Header
Pin Definitions
Pin#
Definition
1
Clock
2
Data
3
PMBUS_Alert
4
Ground
5
+3.3V
35
Chapter 4: Motherboard Connections
C1) monitors the power supply,
2
Advertisement
Table of Contents
