Table of Contents
Advertisement
10
Connecting Optical Fibers to the Ethernet Optical Port
The SmartLogger can be connected to
devices such as an ATB through optical
fibers. You can select the devices to be
connected based on the actual
networking scenario.
1. Insert the optical module into the
SFP1 or SFP2 port of the
SmartLogger.
2. Connect the two cables delivered
with the optical module to the ports
on the optical module.
3. Connect the other ends of the
cables to the ports of the device on
the other side (such as an ATB).
11
Verifying the Installation
No.
1
The SmartLogger is properly installed.
2
All cables are properly connected, without open circuits or short circuits.
Unused ports (such as RF1, RF2, Ethernet optical port, and Ethernet
3
electrical port) are protected by dustproof plugs.
Routing for the power cable and signal cable meets the requirements for
4
routing strong-current and weak-current cables and complies with the
cable routing plan.
Cables are bound neatly, and cable ties are secured evenly and properly in
5
the same direction.
6
There is no unnecessary adhesive tape or cable tie on cables.
12
Powering On the System
Power-on Procedure
12.1
1. Insert the output terminal of the power adapter into the
12V IN port of the SmartLogger.
2. Insert the power cable into the power adapter.
3. Insert the power cable plug into an AC socket.
4. Switch on the circuit breaker of the AC socket.
Check That
16
□ Passed □ Failed
□ Passed □ Failed
□ Passed □ Failed
□ Passed □ Failed
□ Passed □ Failed
□ Passed □ Failed
The rated input of the power adapter
is 100–240 V AC, 50 Hz or 60 Hz.
Select an AC socket that matches the
power adapter.
In a scenario without a smart array
controller, place the power adapter on
the top of the SmartLogger and
secure the power adapter using a
cable tie.
Check Result
Advertisement
Table of Contents
