Table of Contents
Advertisement
Controls & Input connectors
MONITOR ADDRESS
Below the monitor, there is a screen to configure the monitor. Press the UP
or DOWN buttons to change the function. Press the OK button to select the
function. Change the parameter using the UP or DOWN buttons and press
OK again to save the changes.
AHnet ID
Input select
Brightness
Contrast
Backlight
Status information
Selects the number AHnet ID to RS422 to externally control
the monitor
Selects the input source signal (DVIA, DVI1 or DVI2)
Configuration of the monitor brightness level
Configuration of the monitor contrast level
Configuration of the monitor backlight level
List of the monitor status to service
11
Advertisement
Table of Contents
