TABLE OF CONTENTS EC REGULATIONS AND SECURITY SAFETY INSTRUCTIONS SYSTEM DESCRIPTION CONTROLS OSD MENU INPUT CONNECTORS PACKING INSTRUCTIONS WARNING AHNET PROTOCOL INPUT SIGNALS INFORMATION ON DISPOSAL WARRANTY TERMS AND CONDITIONS...
Page 3
Thank you for purchasing an ARTHUR HOLM product. Our product range has been designed for a seamless integration and for Arthur Holm has its origins in the Danish furniture designer Jorgen Alex a maximum reliability. Jensen, who was active during the sixties and the seventies. His design...
EC REGULATIONS AND SECURITY SAFETY INSTRUCTIONS ATTENTION: Do not disassemble or modify the device in any way. Wiring connected to hazardous voltage requires installation by This symbol warns of the presence of dangerous un-insulated qualified personnel or the use of ready-made flexible cables. voltages inside some of the components, of sufficient magnitude to expose people to risk of electronic shock.
1. Open the hatch and remove the two foam protection pieces before AH17D X2HDGA FULL HD 17.3" connecting the monitor. AH19D X2HDGA FULL HD 18.5" 2. Install the unit on a table or desk, in vertical position. AH22D X216GA FULL HD 21.5"...
CONTROLS CONTROLS Remote IR control IR sensor POWER Switch ON/OFF the monitor The IR sensor is located on the lower right side of the screen. MENU Activates the OSD menu on screen Monitor movement controls Cursor control up on the OSD menu On the upper cover plate, there are two buttons to control the UP and DOWN Cursor control down on the OSD menu...
OSD MENU OSD MENU Accessing the menu system Screen • With the OSD off, push the MENU button to activate the main OSD ARC: Adjusts the image aspect on screen menu. ∙ 16:9: Shows the image on screen with 16:9 aspect •...
OSD MENU INPUT CONNECTORS Setup Language: OSD language selection Restore Factory Default: Adjusts the parameters to the initial factory parameters DVI 1/ DVI A DVI-I input signal: Blending: OSD window transparency Connect a DVI (digital) input signal and select DVI 1 on the OSD monitor menu. Use a DVI to VGA adapter to ∙...
PACKING INSTRUCTIONS WARNING Do not use the unit in horizontal position. It could damage the ATTENTION ! Albiral Display Solutions, s.l. mechanical parts of the monitor. c/Fátima 25, 08512 BCN - Spain tel. +34 938 502 376 www.arthurholm.com /www.albiral.com Thank you for purchasing our product, we hope you are completely satisfied with it. If you have any Do not use force to open or close the monitor.
AHNET PROTOCOL AHNET PROTOCOL Communications protocol AHnet protocol Using 5 bytes communication: COMMUNICATION RS422 CONNECTION RJ45 BYTE 0 START BYTE WIRING CAT-5 BYTE 1 ADDRESS BYTE BYTE 2 COMMAND BYTE BYTE 3 VALUE 1 Speed and configuration BYTE 4 VALUE 2 BAUD RATE 38400 DATA BITS...
Page 11
AHNET PROTOCOL AHNET PROTOCOL Picture Commands BITE COMMAND DESCRIPTION RESPONSE CLOSED FA XX 15 00 00 ASK FOR BACKLIGHT LEVEL FB XX 15 00 ZZ FA XX 16 00 00 ASK FOR CONTRAST LEVEL FB XX 16 00 ZZ OPENED FA XX 17 00 00 ASK FOR BRIGHTNESS LEVEL FB XX 17 00 ZZ...
INPUT SIGNALS INFORMATION ON DISPOSAL FOR USERS OF WASTE ELECTRICAL & ELECTRONIC EQUIPMENT AH15D X2HDGA/ AH17D X2HDGA / AH19D X2HDGA / AH22D X216GA This symbol on the products and/or accompanying documents means that used electrical and electronic products should not be mixed with general household...