Lavorwash EASY-R BT Manual page 36

Hide thumbs Also See for EASY-R BT:
Table of Contents

Advertisement

with the available voltage and that the electrical out-
let is grounded (earthed).
Do not damage the feed cable; do not crush or pull on it.
• ATTENTION Make sure that the power cable does
not come into contact with the rotary brushes.
• ATTENTION !!! - The power mains AC 230V ma-
chine has parts, which are connected to the cur-
rent; contact with these could cause grave injuries
or even death.
- Before executing any type of operation on the ma-
chine always disconnect it from the electrical source.
- Never touch electric cables that are defective or worn.
- Before gaining access to the electrical system it is
always necessary to disconnect the machine from
the electrical source by removing the plug from the
socket-outlet.
- In the case of defective, damaged, or cracked electric
cables, replace immediately with authentic replace-
Remove and wash the squeegee
Drain the recovery tank
Drain, rinse with clean water or sanificate the recovery tank
Charge the batteries
Check the acid level in the battery cells (if batteries are not mainte-
nance-free)
Check the wear of the squeegee rubber blades
Open and clean the suction filter
Remove brushes and check for brush wear, foreign bodies and wrapped
belts
Verify the machine general conditions.
Open and clean the solution water filter
Verify that suction hose and conduct are free from obstructions
Check and clean the pivoting wheels
Check wear and function of traction drive belt or chain; if necessary,
adjust belt or chain tension
Clean the brush plate, squeegee support and squeegee
Check the lifting/lowering of the brush plate.
Check the lifting/lowering of the squeegee.
Grease the moving parts.
Check the control cable for the opening of the solution water tap.
Descale water hoses.
ment parts.
- The network of connections must be protected from
water spray.
- The patch cord for the connection of the machine
to the mains power must conforms to current
safety rules.
- The electrical system to which the machine is con-
nected must be equipped with a cutout box.
- It is absolutely forbidden to use the machine in
proximity to swimming pools or stretches of water.
• EMERGENCY SITUATIONS
In case of emergency:
- Immediately disconnect the machine from the
power mains.
- Immediately apply proper first-aid.
If an accident should occur the machine must not be
put into operation until a technician authorized by
the manufacturer has examined it.
7.
MAINTENANCE INFORMATIONS
When needed After every use Weekly Monthly
X
X
36
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X

Advertisement

Table of Contents
loading

Table of Contents