Installing Memory - HP Kayak XA-s02 Install Manual

CAUTION
NOTE
HP Kayak XA-s 02xx PC Workstation - Installing Accessories In Your HP Minitower PC
Workstation

Installing Memory

Installing Memory
Main Memory Modules
If you need more main memory to run your application software, you
can install up to 768 MB of memory in three DIMM slots.
Main memory upgrades are available in single 32 MB, 64 MB, 128 MB
and 256 MB Non-ECC SDRAM or 64 MB, 128 MB and 256 MB ECC
SDRAM memory modules. You should note that only 100 MHz memory
modules should be used to upgrade your PC Workstation.
Static electricity can damage electronic components. Turn off all
equipment. Do not let your clothes touch the accessory.
To equalize the static electricity, rest the accessory bag on top of the
power supply while you are removing the accessory from the bag.
Handle the accessory as little as possible and with care.
To install a main memory module:
1 Disconnect the computer's power cord and any LAN or
telecommunications cable.
2 Remove the computer's cover (see page 3).
3 Remove the fan connection to the system board.
Refer to the illustration on page 8 for steps 3 and 4.
4 Press the retaining buttons on each side of the HP UltraFlow airflow
guide and lift it out of the PC Workstation's case.
5 Remove the transparent airflow guide covering the processor
sockets (if needed).
6 Remove the floppy disk drive data cable from the system board.
7 The location of the memory module slots is shown here.
8 English