Connecting Devices - HP Kayak XA-s02 Install Manual

Which Data
Connectors to Use
Which Power
Connectors to Use
HP Kayak XA-s 02xx PC Workstation - Installing Accessories In Your HP Minitower PC Workstation

Connecting Devices

If you add an IDE Zip drive, hard disk drive, CD-ROM drive, CD-RW
drive, or tape drive, you need to connect it to power and data cables.
Your PC Workstation has the following cables and connectors on the
system board which may be used by mass storage devices:
A flexible disk drive cable with a single connector. This supports a
•
flexible disk drive (the connector is attached to the flexible disk
drive supplied).
Two Ultra ATA/33 IDE drive connectors that support four fast IDE
•
devices. If you install a CD-ROM drive, CD-RW drive, a Zip drive, or
a third hard disk drive, connect it to this cable.
There are two different types of power connectors—these are shown
below.
Some of the power connectors will already be connected to devices. If
you install a device that requires a different connector, the connector
converter should be supplied with the device.
Installing Mass Storage Devices
Power Cables for Hard Disk
Drives, Zip Drives, Tape Drives,
CD-RW, and CD-ROM Drives
Power Cable for 3.5-inch
Flexible Disk Drive
English 11