HP Kayak XA-s02 Install Manual page 20

When an IDE CD-ROM
Drive Is Installed
When a Flexible Disk
Drive Is Installed
HP Kayak XA-s 02xx PC Workstation - Installing Accessories In Your HP Minitower PC
Workstation
Installing Mass Storage Devices
9 Slide the power supply back into position, and tighten the four self-
retaining screws.
10 Remove the plastic panel from the cover by pulling the panel from
the left and unhinging its right-hand side. Store the panel in a safe
place.
11 Install any other accessories before replacing the cover and
completing the installation.
Completing the Installation of a Drive
1 Switch on the computer and press
2 In the Setup program, select the Advanced menu, the IDE Devices
submenu. Check that the CD-ROM drive has been detected on the
IDE channel.
3 Press to save and exit the program.
1 Switch on the computer and press
2 In the Setup program, select the Advanced menu, the Flexible Disk
Drives submenu, and check that the drive has been detected.
3 Press to save and exit the program.
20 English
Unclip and lift out
the plastic panel
when
Setup
when
Setup
appears.
appears.