Usb-To-Uart Interface; Table 15 Uart Hyperterminal Settings - Microsemi SmartFusion UG0209 User Manual

Component Descriptions and Connections
5.11

USB-to-UART Interface

USB-to-UART interface is Included on the evaluation board with ESD protection
This interface includes an integrated USB-to-UART bridge controller (U16) to provide a standard UART
connection with the SmartFusion MSS UART0 port. One application of the USB-to-UART interface is to
allow HyperTerminal on a PC to communicate with the SmartFusion cSoC. HyperTerminal is a serial
communications application program that can be installed in the Windows operating system. A basic
HyperTerminal program is usually distributed with Windows. With a USB driver properly installed, and the
correct COM port and communication settings selected, use the HyperTerminal program to communicate
with a design running on the SmartFusion cSoC.
The following table lists the supported UART parameters for HyperTerminal applications.
Table 15 • UART HyperTerminal Settings
Supported HyperTerminal Parameters
Baud Rates Data Bits
110 5, 6, 7, 8
300
1200
2400
4800
9600
19200
38400
57600
115200
230400
460800
921600
Parity Types
NO/ODD/EVEN/MARK(1)/SPACE(0)
UG0209 User Guide Revision 7.1
(Figure 18, page 19).
STOP BIT
ONE/ONE-HALF/TWO
18