Table 2 Smartfusion Evaluation Kit Board Components - Microsemi SmartFusion UG0209 User Manual

Introduction
The board includes the following:
• Ethernet and USB-to-UART interface for communication with the Ethernet and UART peripherals of
the SmartFusion MSS
• SPI flash that interfaces with the SPI peripherals of the SmartFusion MSS
2
• I C Interface
• Current monitoring and temperature monitoring circuits
• RVI header for application programming and debug from either Keil U-LINK or IAR J-Link, integrated
low-cost programmer to enable programming and debugging from Microsemi design tools,
FlashPoint and Soft Console.
The following table lists the SmartFusion Evaluation Kit board components.
Table 2 • SmartFusion Evaluation Kit Board Components
Name
A2F200M3F-FGG484
SPI FLASH
OSC-20
OSC-32
USB/UART
ETHERNET
CURRENT
TEMP
RVI HEADER
FP3_PROG
PUSH-BUTTON
SWITCHES
LEDS
USER I/Os
PUSH-BUTTON RESET Push-button system reset for SmartFusion cSoC system
MIXED_CONN100
Description
Microsemi SmartFusion cSoC with hard ARM Cortex-M3 processor
8 MByte SPI flash Atmel AT25DF641-MWH-T connected to SPI port 0 of the
SmartFusion MSS
20 MHz / 20 PPM clock oscillator
32.768 KHz low power oscillator
USB-to-UART adapter chip CP2102 and connector interfacing with UART
port 0 of the SmartFusion MSS
RJ45 connector (Ethernet jack with magnetics) interfacing with National
Semiconductor 10/100 PHY chip DP83848C in RMII mode interfacing with
Ethernet port of SmartFusion MSS (on-chip MAC and external PHY)
Current monitoring using thumbwheel POT (RV1)
Temperature monitoring with temperature diode
RVI header for application programming and debug from Keil U-LINK or IAR
J-Link
Integrated low-cost programmer
Two push-button switches connected to GPIOs, which can be used as test
and navigation switches
Eight active low LEDs that can be connected to user I/O for debug to power
on the board
Five general purpose user I/Os that can be used for Direct-C signaling,
interfacing and debugging purposes
Mixed signal header
UG0209 Revision 7.1 4