Attaching The Stand - Olympus U-MDOB3 Instructions Manual

1
2 2
3
d
18
b
a
Rubber leg position Rubber leg position
c
e
2

Attaching the stand

1
Place the side viewer on the desk upside down and screw the b
portion of the stand into the mount screw hole a of the side viewer.
2
Loosen the stand height lock knob c . Rotate the
in the picture and place one of three rubber legs attached to the back
side of the base of the stand so that it is parallel to the tube of the side
viewer as shown in the picture.
3
Move the portion shown in the picture up and down so that the
d portion of the stand is 24 mm, and tighten the stand height lock
knob e .
If there is a difference in height between the desk top surface
TIP
where the microscope frame is installed and the desk top
surface where the side viewer is installed, adjust the length
of the d portion of the stand. For example, if the height
difference is 5 mm (if the desk top surface of the microscope
frame is higher than the desk top surface of the side viewer),
d will be 29 mm.
portion shown