Adjusting The Stand Height - Olympus U-MDOB3 Instructions Manual

a
b
c
6

Adjusting the stand height

Adjustment order
Adjust the stand height in the following order.
1
Look through the eyepieces at the main observer position
display the pointer using the pointer color switching lever a . Use the
pointer control lever b to move the pointer to the center of the field of
view. (For detailed operating procedures of the pointer color switching
lever and the pointer control lever, see "3-3 Pointer operation" (page 13).)
2
Look through the eyepieces at the assistant observer position
there is a deviation in the displayed pointer position, adjust the stand
6
height with the stand height lock knob c so that the pointer comes
to the center of the field of view.
Be sure to adjust the stand height.
TIP
If the stand height is not adjusted, following phenomena may
appear.
· The periphery areas of the field of view of the assistant
· The deviation in the field of view occurs between the main
· The field of view of the assistant observer is colored.
The farther away from the center of the system you apply
NOTE
the force to the observation tube, the larger the force to be
applied to the entire system becomes. Do not apply the
excess force on the observation tube carelessly.
Assistant
observer
2
2
Main
observer
observer are cut off.
observer and the assistant observer.
Assistant
observer
2
2
1
and
1
2
. If
21