MAAX 103534-000-270-001 Installation Instructions Manual page 7

Installation Procedure
Understanding Framework Construction
The BT-3060 Bathtub is approximately 60" wide, 30" deep, and
16" high. It features a 1-1/2" threshold flange and special clips
for secure attachment to the framework enclosure.
IMPORTANT NOTICE
Dimensions are approximate sizes only. Measure the actual
bathtub prior to building the framework to determine the exact
size. Add 3/8" to the width measurement and at least 3/16" or
more to the depth measurement of the bathtub to correctly
size the framework opening.
Note: Temporarily remove the protective plastic liner
and inspect the bathtub for damage. If damage is found,
immediately report it to the store of purchase. Replace the
plastic liner during bathtub installation and during construction
of the framework.
MAAX cannot anticipate every possible installation situation
or condition. The variety of installations possible for this
bathtub kit may require procedures other than those shown.
Plan ahead to ensure that framework construction is correctly
sized, plumb, and square. Check local building code before
constructing the framework enclosure.
Bathtub Clip
(not used when installed with Nextile wall system)
The key to a good bathtub installation is proper fit within the
stud wall framework. Remember these important points to
ensure a smooth installation.
• Completely read and understand this manual and the
appropriate bathtub solid surface wall panel installation
manual prior to beginning the project.
• Measure the actual bathtub and use these dimensions
to build or modify the stud wall framework to fit. Up to a
3/16" gap between the framework and the MAAX bathtub
flange is acceptable.
Installation Options
m The bathtub can be installed with the flange directly against
the stud wall framework and 1/2" moisture-resistant wall
board installed above the bathtub flange.
m The bathtub can be installed with the flange directly against
the stud wall framework and a Alcove Wall Kit can be
installed directly onto the wall stud framework. Refer to
the alcove wall kit manual for more information, prior to
building/modifying the framework.
m The bathtub can be installed with the flange against existing
moisture-resistant wall board with a second layer of 1/2"
moisture-resistant wall board added above the bathtub flange.
Note: The bathtub should be set into place prior to wall
finishing. This unit should not be installed directly against a
masonry wall. First install furring strips or other anchoring
materials, then secure the bathtub to this framework.
7
BT-001