Table of Contents
Advertisement
Available languages
Available languages
Installation Procedure
4.
Trial fit the bathtub. Make sure the bathtub is level and
all feet on the bathtub are making firm contact with the
subfloor. Make sure all plumbing connections align properly.
a.
It may be necessary to place shims under the bathtub
for best overall subfloor contact. (See Special
Application For Sound Deadening Or Fireproofing
section in this manual).
b.
It may also be necessary to shim between the bathtub
flange and the enclosure framework, or the existing
wall board, for best overall bathtub flange clip contact.
BT-007
IMPORTANT NOTICE
Make sure all the bathtub clips contact (fit against) the studs
or existing wall board. If a gap exists, shim behind the clips to
prevent damage to the bathtub flange when the bathtub clip
nails are installed.
BT-008
5.
The bathtub is now ready for a slurry of fast drying cement
(Quikrete or other product). Place up to a 1/2" thick layer
of mortar or thinset on the floor. This will ensure complete
contact and support by the existing subfloor, eliminating
bathtub flex during normal use.
IMPORTANT NOTICE
This product is not designed for above-the-floor mounting (the
base of the bathtub must be fully supported by the subfloor).
Any application of this type, or application other than that
covered in this manual, will void the warranty.
6.
Place the bathtub into the framework enclosure and firmly
press it into the mortar/thinset. The bottom front edge of
the bathtub should contact the floor surface. Level the
bathtub in both directions.
7.
Secure the bathtub clips to the studs with large head
roofing nails (one nail per clip). Allow the mortar/thinset to
cure for 24 hours.
8.
Make sure the protective plastic liner is in the bathtub and/
or place cardboard, or similar scratch-resistant material,
in the bottom of the bathtub to prevent possible damage
during further construction.
9.
Follow all local building codes and manufacturers
instructions to install the bathtub enclosure walls and
install the plumbing fixtures.
11
BT-009
Advertisement
Table of Contents
