Standard Features - Compaq Deskpro AP500 Reference Manual

1-2 Product Features

Standard Features

The Compaq Professional Workstation AP500 offers the following standard
features. Features may vary depending on your model. For a complete listing of
the hardware and software installed in your workstation run the INSPECT
utility as described in Chapter 2.
Compaq Professional Workstation AP500 Standard Features
Processors
Number of Processors
L2 Cache Size
Memory
Optional Memory
Upgrades
Memory Controller
Error Checking and
Correcting (ECC) Memory
Graphics Controller
Expansion Slots
Drive Controller
Writer: Jeff Parmenter Project: Compaq Professional Workstation AP500 Reference Guide Comments: 338521-002
Table 1-1
Feature
400-MHz or 450-MHz Intel Pentium II or 500-MHz
Pentium III embedded termination
One processor, upgradable to two
512 KB
100-MHz ECC registered SDRAM DIMM, 4 DIMM sockets,
upgradable to 1GB
Supports 100-MHz ECC 32-MB, 64-MB, 128-MB, or
256-MB Registered SDRAM DIMMs
800MB/s single channel memory controller
Uses an encoding scheme for memory error detection and
correction. (Specifically, this feature detects and corrects all
single-bit memory errors, and detects and reports double-
bit errors.)
2D, 2D/3D, or 3D graphics controllers
6 slots total: 3 dedicated PCI, 1 PCI/ISA shared, 1 dedicated
ISA, 1 AGP (all connectors populate full length cards)
IDE Controller, Wide-Ultra SCSI, Wide-Ultra2 SCSI
File Name: B-CH01.DOC Last Saved On: 2/11/99 8:09 PM
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED
Description
Continued