Compaq Deskpro AP500 Reference Manual page 31

2-4 Compaq Setup and Diagnostic Software
Computer Setup Features
View information regarding IDE devices
connected to the system.
NOTE: ATAPI devices (CD-ROM) are listed
as ATAPI devices.
Enable/disable IDE drive translation.
Specify the boot order of installed peripheral
devices (such as diskette drive, hard drive, or
CD-ROM drives).
Enable/disable serial and parallel port and/or
set resources for onboard system devices
(serial port, parallel port, and other system
devices).
Set the printer mode (flexible/standard).
Set the Num Lock state at power-on.
Disable energy save mode.
Select time-out values.
NOTE: These selections appear only when
energy save mode is set (default).
Enable/disable power LED blink in suspend
mode.
NOTE: This selection does not appear if the
energy saver mode is disabled.
Writer: Jeff Parmenter Project: Compaq Professional Workstation AP500 Reference Guide Comments: 338521-002
Continued
Task
File Name: C-CH02.DOC Last Saved On: 12/14/98 9:24 AM
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED
Computer Setup Selection
Click Built-in Devices, then click Storage.
The information is displayed under IDE
Devices.
Click Built-in Devices, then click Storage.
Under IDE Devices, select IDE Drive
Translation.
Click Built-in Devices, then click Storage.
Click Boot Order.
Click Built-in Devices, then click
Communications. Select the appropriate
options under Serial Ports or Parallel
Port.
Click Built-in Devices, then click
Communications. Under Parallel Port,
select the appropriate Bi-directional Port.
Click Built-in Devices, then click Input
Devices. Under Keyboard, turn on Num
Lock State At Power-on.
Click Built-in Devices, then click Power
Management. Select Energy Save
Disabled.
Click Built-in Devices, then click Power
Management. Under Hard Drive and/or
Monitor, select the Time-out value .
Click Built-in Devices, then click Power
Management. Select Blink LED during
Energy Save.
Continued