Installing A 10,000 Rpm Hard Drive In Bays 5 Or 6 - Compaq Deskpro AP500 Reference Manual

Installing a 10,000 rpm Hard Drive in
Bays 5 or 6
Drive bays 5 and 6 can be configured with a 10,000 rpm hard drive. The
installation for the hard drive is basically the same as installing a 7200 rpm hard
drive, except you will be installing a cooling fan. A cooling kit is required for
the hard drive when you install it in bays 5 or 6. To install a 10,000 rpm hard
drive:
NOTE: Before installing a SCSI device, please read "SCSI Cables and
Guidelines" later in this chapter.
To install a 10,000 rpm hard drive:
1. Turn off the workstation and disconnect the power cord from the
grounded AC outlet and the back of the workstation.
2. Remove the following components:
side access panel
front bezel
cooling shield
3. Refer to the following illustrations to install a 10,000 rpm hard drive in
bays 5 or 6.
Figure 8-9. Installing a 10,000 rpm hard drive in the hard drive bracket
Writer: Jeff Parmenter Project: Compaq Professional Workstation AP500 Reference Guide Comments: 338521-002
File Name: I-CH08.DOC Last Saved On: 2/11/99 8:29 PM
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED
Compaq Professional Workstation AP500 Reference Guide
8-9