Compaq Deskpro AP500 Reference Manual page 136

Solving Network Problems
Problem
Diagnostics reports a
failure.
Writer: Jeff Parmenter Project: Compaq Professional Workstation AP500 Reference Guide Comments: 338521-002
File Name: L-CH11.DOC Last Saved On: 12/16/98 11:31 AM
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED
Continued
Possible Cause
Possible resource conflict
with another expansion board.
The cable is not securely
connected.
The cable is attached to the
incorrect connector.
There is a problem with the
cable or a device at the other
end of the cable.
The network controller is
defective.
Network controller interrupt
overlaps the interrupt of an
expansion board.
Compaq Professional Workstation AP500 Reference Guide
11-13
Possible Solution
Factory default is 300h to
30Fh for Ethernet. Either
remove and reconfigure
the conflicting expansion
board, or reconfigure the
network controller. If the
address is changed,
ensure that the drive
parameters match the
new I/O address for the
network controller.
Ensure that the cable is
securely attached to the
network connector and
that the other end of the
cable is securely
attached to the correct
device.
Ensure that the cable is
attached to the correct
connector.
Ensure that the cable and
device at the other end
are operating correctly.
Contact your Compaq
authorized service
provider.
Run the Setup utility and
modify the network
controller memory value.
Continued