Table of Contents
Advertisement
Note
•
Both outputs OUT1 and RELAY1 are switched always simultaneously.
Tamper Switch Connection
®
2N
IP Uni is equipped with a tamper switch for detection of unauthorized penetration into the
device. After correct and complete installation of the device the tamper switch is closed. Tamper
switch opens immediately when the front panel is removed. Tamper switch contacts are
available on terminal block TAMPER SWITCH.
Device Resetting
®
2N
IP Uni is equipped with a RESET button. Push the button for 30 s to reset the factory default
values, deleting all the data stored in the device.
Caution
•
In case of resetting the factory default settings on a device with a version of
firmware 2.18 or higher it is necessary to reprogram the
®
2N
Security Relay using the instructions from section
Connection.
Device Restarting
Press the RESET button shortly (< 1 s) to restart the system without changing configuration.
Note
•
The time interval between the short press of RESET and reconnection after restart
is 30 s for 2N
®
IP UNI.
Installation manual 2N® IP Uni
2.5 Extending Module
36 / 58
Advertisement
Table of Contents
