HP Compaq SP700 User Manual page 9

Speaker
To remove the speaker:
1. Perform the service preparations shown on page 3-2, remove the workstation feet, and
place the workstation on its side.
2. Remove the side access panel.
Unplug the speaker connector from the system board 1, and remove the cable from the
3.
clip.
Remove the four T-15 screws securing the front of the speaker to the chassis 2.
4.
5. Remove the speaker from the workstation by sliding it back, then lifting it up and out of
the chassis 3.
Figure 3-8. Removing the speaker
To replace the speaker, reverse the above procedure.
1
2
Compaq Professional Workstation SP700 Maintenance and Service Guide
3
3-9