HP Compaq SP700 User Manual page 48

3-48 Removal and Replacement Procedures
Loosen the middle thumbscrew that holds the processor in place 1. Open the two release
3.
latches 2, then slide out the processor.
NOTE: This step is applicable for removing the terminator board located in the secondary
processor slot of a single-processor system and for removing a second processor from the
secondary processor slot of a dual-processor system.
Figure 3-40. Removing the processor and heatsink assembly
To replace the processor and heatsink assembly, reverse the above procedure.
IMPORTANT: Before replacing the I/O bracket assembly, read "Important Guidelines for I/O
Bracket Assembly Replacement" earlier in this chapter.
2
CAUTION: After connecting the power cord to the grounded AC outlet and to the
workstation, DO NOT turn on the power switch if the power LED is a steady amber
color. A steady amber color indicates that the I/O bracket assembly, processor(s),
or terminator board (if installed) is not seated properly.
1
2