HP Compaq SP700 User Manual page 26

3-26 Removal and Replacement Procedures
4. Remove the two screws that secure the diskette drive.
5. Pull the diskette drive straight out of the drive cage.
Figure 3-22. Removing the diskette drive
To replace the diskette drive, reverse the above procedure.
NOTE: If you are replacing the drive with a new one, transfer the guide screw from the old drive
to the new one. Be sure the guide screw is placed in the first hole on the right side of the drive.
Note that extra guide screws are provided on side of the air plenum.
CAUTION: Use only 3/16-inch or 5-mm long screws. Longer screws can damage
the internal components of the drive.
CAUTION: When servicing the workstation, be sure cables are placed in their
proper locations during the reassembly process. Improper cable placement can
damage the computer.