Table of Contents
Advertisement
BIOS Support USB Keyboard
If Enabled is selected in the above feature, this feature will appear.
If your USB devices cannot be detect automatically by the system BIOS or
some driver diskettes came with your USB devices, please set at DOS for
allowing you to install the driver. The options are: Setup (Default), DOS.
Onboard FDC Controller
When enabled, the floppy diskette drive (FDD) controller is activated.
The options are: Enabled (Default), Disabled.
Onboard UART 1
If the serial port 1 uses the onboard I/O controller, you can modify your
serial port parameters. If an I/O card needs to be installed, COM3 and
COM4 may be needed.
The options are: 3F8/IRQ4 (Default), 3E8/IRQ4, 2F8/IRQ3, 2E8/IRQ3,
Disabled.
Onboard UART 2
If the serial port 2 uses the onboard I/O controller, you can modify your
serial port parameters. If an I/O card needs to be installed, COM3 and
COM4 may be needed. The options are: 2F8/IRQ3 (Default), 3E8/IRQ4,
2E8/IRQ3, 3F8/IRQ4, Disabled.
OnBoard UART 2 Mode
Allows you to select the IR modes if the serial port 2 is used as an IR port.
Set at Standard, if you use COM2 as the serial port as the serial port, instead
as an IR port. The options are: HPSIR, ASKIR, Standard (Default).
IR Duplex Mode
This feature allows you to select the infrared data transaction way.
The options are: Half (Default), Full.
Use IR Pins
Allows you to select the active signals of the reception end and the
transmission end. The options are: IR-RX2TX2 (Default), IR-RX TX.
Onboard Parallel Port
Allows you to select from a given set of parameters if the parallel port uses
the onboard I/O controller. The options are: 378/IRQ7 (Default), 278/IRQ5,
3BC/IRQ7, Disabled.
Parallel Port Mode
Award BIOS Setup
53
Advertisement
Table of Contents
